COMET S0111 Features

• S0111 Thermometer for External Probe with Display
• Included traceable calibration certificate from the manufacturer - Comet
• Fast data transfer to the PC (full memory for approximately 30s)
• Variability of connection to the computer - USB, RS232, Ethernet, GSM modem
• Permanent connection to the PC enabled, data is possible to download even during logging
• Large data memory 32000 values
• Optional display of minimum and maximum measured values (reset of min/max memory from PC or by the magnet)
• A dual level alarm is enabled for each channel, the alarm is indicated by blinking of the LED diode
• Two alarm modes are enabled: instant or with memory (detected alarm is indicated permanently till alarm memory is cleared from the PC)
• Robust watertight case
• Easy installation, locking enabled
• Low power consumption from the battery, battery life up to 7 years
• The indication of remaining battery life, easy replacement of the battery
• A standard temperature sensor is Pt1000/3850ppm, switchable to Ni1000/6180ppm external probes at the range -50 to +150°C
• It is possible to combine temperature measurement with logging of contact state (e.g. door contact)
• Logging start/stop is enabled in several ways: at certain time and date programmed from computer, by delivered magnet
• Also special logging mode is enabled, when logging runs only, if some of measured values are out of adjusted alarm limits
• Each logger is possible to describe with text of maximum 32 characters
• Each channel is possible to describe with text of maximum 16 characters
• Password protection is enabled to prevent unauthorized manipulation with logger